Subduct Pulling Eye with Clevis (Carrot)

Designed to install polyethylene ducting using a screw-in tapered thread to grip the inner diameter of the duct. The pulling eyes are typically used to install inner duct inside a larger duct and are designed with cutting edges to actually cut a thread in the bore of the ducting, similar using a tap to cut a thread in steel. This helps to ensure a reliable grip requiring just 7 or 8 full threads of contact.

With clevis pin and eye to attach draw rope etc

Units are tapered, threaded and zinc plated

Available in sizes:

24 - 29mm and 29 - 37mm

Mills Part Numbers

S83-9322 Subduct Pulling Eye with Clevis (Carrot) 24-29mm

S83-4867 Subduct Pulling Eye with Clevis (Carrot) 29-37mm