Fremco Mini Blowing Junction Block for Manual Blowing

The mini blowing junction block is used as a junction when blowing fibre in two directions, and there is a loop left because the regular blowing machine does not fit into the manhole/excavation making it the perfect accessory for a MiniFlow Rapid.

The mini blowing junction block can also be used to blow a cable (by hand in short distances) from a narrow spot where there is no room for a regular blowing machine.

It’s made from surface treated aluminium and can withstand the same air pressure as the MiniFlow Rapid and uses the same type of cable seals.

Available in the following sizes:

For 7 - 10mm microduct.

For 8 - 10mm microduct.

For 8 - 12mm microduct.

For 8 - 14mm microduct.

For 8 - 16mm microduct.

Mills Part Numbers

103-10413 Mini Blowing Junction Block for Manual Blowing 7-10 mm Microduct
103-10308 Mini Blowing Junction Block for Manual Blowing 8-10 mm Microduct
103-10309 Mini Blowing Junction Block for Manual Blowing 8-12 mm Microduct
103-10350 Mini Blowing Junction Block for Manual Blowing 8-14 mm Microduct
103-10310 Mini Blowing Junction Block for Manual Blowing 8-16 mm Microduct